Amplificador Integrado 120 W Brinkmann Integrated 220v 120 W

SONIDO PAUL Amplificador integrado 120 W Brinkmann Integrated 220V. Características One of the purest amplifiers in the high-end audio world is our Integrated. Built just for music in the most uncomprimising way: it has only the volume control and an input selector in the signal chain. When connected to the mains, the amplifier is automatically set to 'stand-by' as there is no power-on-switch. The quiescent current of the output-stage is switched off and the signal is muted through the dedicated switch on the frontpanel. There are four line and two digital inputs, the latter drive the optional DAC-module. The signal is fed directly to the blue Alps-pot via the input selector and then sent through the active electronics, thus the Integrated should be seen as a combination of a high sensitivity stereo power amplifier with passive preamplifier. In addition to that, there is a buffer stage for the tape recording output which carries always the signal of the choosen input. Furthermore there is a dedicated headphone amplifier which is activated when the Integrated is in stand-by. The Headphone-output-socket is located on the frontpanel and the relative circuit has been optimised for headphones with an impedance of at least 200 Ohms. It is important not to load the inputs with DC, as all stages of the amplifier are DC- coupled. A typical small amount of DC is nulled out by a DC-servo-regulator. To make the amplifier become a truly digital device , there is the optional DAC-module to be used: its current-to-voltage stage is built using a miniaturised tube for best sonic results. The digital signals of CD-players, Dat-recorders or digital Tuners may have sample-frequencies from 32 to 48 kHz, the DAC-module is automatically adjusting itself to the input frequency. The two digital inputs are switched electronically: when a signal reaches dig 1, the output-tube is heated independently from the input chosen, i.e. the tube can be pre-heated by switching on a digital signal source while a different line input is working. Brinkmann Integrated Specifications Output power 8 Ohm 75W Output power 4 Ohm 120W Damping factor 8 Ohm 65% THD 0,01% Line inputs 4 Digital inputs 2 Input impedance line 20kOhm Input Sensitivity line 400mV Input impedance digital 75Ohm Input Sensitivity digital 0,5Vss Samplingrates 32/44.1/48kHz Wordlength 18bit Width 440mm Height 80mm Depth 370mm

---

Características adicionales:

• Profundidad: 40 cm
• Altura: 20 cm
• Es puenteable: No
• Condición del ítem: Nuevo
• Modelo: Brinkmann Integrated
• Cantidad de canales: 2
• Potencia de salida RMS: 120 W
• Ancho: 40 cm
• Con garantía: No